Duty is derived from component with highest duty
rate. Set HTS is in 50 Record. 70 Record has HTS of highest duty rate,
equivalent ADVAL rate, quantity of all items. Additional HTS numbers
not required.
Sets under GRI 3(B) or 3(C) -
HTS number in which the rate of duty is derived is shown first with
an "X" in Secondary SPI field (position 80).
Each article in the set (including the one above) is reported ON A
SEPARATE LINE. Quantity and value are reported. Secondary SPI has a "V".
There must be at least two lines with "V".
Watches/Clocks -
HTS number and duty for the movements is in the 50 record.
Other components are in the 70, 80, 81 record with VALUE, QUANTITY
and DUTY.
Knife Sets
On the Worksheet: Put the set HTS number on the first line with the
total number of pieces. Put "O" in the I/O column. Put the HTS number
for duty computation as a Secondary Number with "I" in the I/O column.
You will probably have to calculate an equivalent ADVAL rate and edit
the 7501 data to change the duty rate.
GRI Sets
(This currently will only work where the 7501 data is NOT sorted, eg ATL
and MPL). Enter each item as a separate line on the Worksheet. The
first line has the value and quantity data necessary to calculate the
duty and an "I" in the I/O field. Repeat the first line and add all other
lines with appropriate reporting data and an "O" in the I/O field.
After calculating duty, expand from the 7501 lines and put an "X" in the
first line (where the duty was calculated) and put a "V" in the other lines.
(There must be at least two.)
9802
If you have a 9802 that included the GRI sets you need to repeat the entire
duty computation line (9802 and the HTS used to compute the duty) and then
all other related HTS numbers as separate lines. Put the "X" on both the
9802 and the additional number on the first line. Put the "V" on both the
9802 and the additional number on the 2nd line and the "V" on the remaining
lines.
On the 7501 screen, expand the first line and add an "X" in the SPI field.
Expand each additional line and add a "V" in the SPI Field.
Watches and Clocks
On the Worksheet, enter the movement as the first HTS number. Enter
all the additional numbers as Secondary Numbers. Each line should have
its own quantity and value information and an "I" in the I/O field.